Infrared Photocell Gate Sensor For Sliding Or Swing Gate Motor
Infrared Photocells Sensors Electronic Gate Opener Accessories
Gatech Automation Industrial Co.,limited was established in 2005, Located in Hangzhou, Zhejiang Province,China. We are Professional manufacturer for Gate and Door Automatic Operators in China. We could provide quality ODM/OEM service for customers in the world.
Our main products:Auto-barrier gate,Roll up door opener, Swing gate opener, Sliding gate opener,Swing gate opener,Entrance control system etc.
Single beam active intruder infrared detector with built-in AGC control circuit . Could effectively prevent sunlight.Beautiful structure, small size , easy to install, Totally- sealed rainproof and moth proof design, Can be widely used for access control system , parking lot . defence wall, door and window, balcony , garage, passage and other places.
Specification:
1. Infrared Frequancy: 1.92khz
2. Power supply: 12 to 24 VDC /AC
3. Wave length: 940nm
4. Input : r*15ma - t*30ma
5. Operating temperature : --20 degrees to 50degrees
6. Relay output : 1A max *36 v
7. Dimension: 49.2 x 76 x 21.6mm
8. Range : range can be reduced to 30% in bad weather conditions : for rain ,dust ,etc
Working Environment and Conditions:
1) Air temperature change as well as season.
2) Relative humidity:90%(25°C).
3) Voltage and frequency is in line with the product nameplate.
4)Short hour working system, continuous operation not less than 5 mins.
Delivery attention:
1.DHL: please offer your detailed address with zip code for delivery checking.
2.TNT: please kindly noted that TNT samples can't including battery.
3. Sea: please check weather you need original Bill of Lading or can be telex released.
4. China post: it takes months, and may lost on the way.
Payment terms
1. Payment: T/T,Paypal,Western Union ,30% deposit before production,70%
balance paid before delivery
2. Shipping freight are quoted based on your requests
3. Discounts are offered based on order quantities
Warnings to installers and users
1. Before installation and use, please read this Manual carefully.
2. Avoid installing the product where there are vibrations, high-
temperature, high-humidity, flammable, explosives, dust or corrosive
gases.
3. As there is high voltage electricity inside the product, non-
professionals should not arbitrarily open the lid to avoid electric
shock. For debugging, look for professionals for help.
4. For loss and damage due to unauthorized changes to the original
design of the product, the original manufacturer will assume no
liability or responsibility.
5. An air-break switch must be connected with the power supply
input connector.
6. Before power on and debugging controller, manually adjust the
barrier to the middle position.
7. The power must be cut off before manually operate the barrier.
8.Make sure that the path is unobstructed when the barrier is running.
9. Safety devices such as Air-wave switch and Photocell are highly
recommended. Check and test them periodically to ensure that they
are effective.
10. Please properly dispose the accessories including plastic bag and
screws to avoid the hazards such as mistaking and chocking.
11. Please keep this Manual properly for reference.
Product Tags:
|
|
Infrared Photocell Gate Sensor For Sliding Or Swing Gate Motor Images
|
